Brother AX-10 Bedienungsanleitung PDF herunterladen (Seite 18)

CARE OF UNIT

Do not allow any foreign matter to enter the

Interior of the typewriter or get between the

keys. Be especially careful of metal objects

such as paper clips and staples.

Never use volatile liquids such as thinner or

benzine to clean the exterior surface of the

typewriter. Use only a soft cloth dampened

with a mild detergent solution.

Do not locate your typewriter

where it is exposed to direct

sunlight, heat or intense vibration.

Do not block the ventilation slits

provided in the back of the unit to

protect against the danger of

overheating.

When the typewriter is not in use,

be sure to replace the keyboard

cover.

TROUBLESHOOTING

If any operational difficulty arises, check below. If the trouble can not be overcome by

following these instructions, then consult your Brother dealer.

Typewriter remains at a standstill with the

on-off switch set at ON.

(1) Make sure the power cord is plugged in.

(2) Be sure the top cover is closed.

Printing is faint or does not appear.

(1) Be sure daisy wheel is properly set.

(2) Check positioning of cassette ribbon.

(3) Check to see that the ribbon has not been fully used.

Correction cannot be made.

(1) Be sure the correction tape is properly set and passed

through the tape guides.

(2) Check to see that the correction tape has not been fully used.

(3) Be sure the correction tape has been properly selected to

match the cassette ribbon.

Cassette ribbon lifts up and remains up

(this rarely happens).

Turn the power off first. Then turn it on again while holding down

the code key and the pitch selector.

1 2 ... 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Brother AX-10 Bedienungsanleitung Seite 18