Brother HL 5450DN Bedienungsanleitung PDF herunterladen (Seite 44)

Control panel setup

Ethernet (wired network only) 4

Ethernet link mode. Auto allows the print server to operate in 1000BASE-T full duplex (For HL-6180DW(T)),

100BASE-TX full or half duplex, or in 10BASE-T full or half duplex mode by auto negotiation.

Note

• If you set this value incorrectly, you may not be able to communicate with your print server.

• For details about 1000BASE-T full duplex operation, see Gigabit Ethernet (wired network only) (For

HL-6180DW(T)) uu page 48.

Wired Status 4

This field displays the current wired network status.

Setup Wizard (wireless network only) 4

The Setup Wizard guides you through the wireless network configuration. (For more information:

uu Quick Setup Guide or Manual configuration from the control panel uu page 18.)

WPS (Wi-Fi Protected Setup)/AOSS™ (wireless network only) 4

If your WLAN access point/router supports either WPS (PBC

) or AOSS™ (Automatic Wireless mode), you

can configure the machine easily. (For more information: uu Quick Setup Guide or One push configuration

using WPS (Wi-Fi Protected Setup) or AOSS™ uu page 27.)

Push Button Configuration

WPS (Wi-Fi Protected Setup) w/PIN Code (wireless network only) 4

If your WLAN access point/router supports WPS (PIN Method), you can configure the machine easily. (For

more information, see Configuration using the PIN Method of WPS (Wi-Fi Protected Setup) uu page 29.)

WLAN Status (wireless network only) 4

Status 4

This field displays the current wireless network status.

Signal 4

This field displays the current wireless network signal strength.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 119 120

Keine Kommentare

Brother HL 5450DN Bedienungsanleitung Seite 44