Brother NV1250D Bedienungsanleitung PDF herunterladen (Seite 36)

GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Threading the needle

This section describes how to thread the needle.

Memo

The needle threader can be used with sewing

machine needles 75/11 through 100/16.

z Thread with a thickness of 130/20 or thicker

cannot be used with the needle threader.

z The needle threader cannot be used with the

wing needle or the twin needle.

z If the needle threader cannot be used, refer

to “Threading the needle manually (without

using the needle threader)” (page 35).

Pull the end of the thread passed through the

needle bar thread guide to the left, and then

pass the thread through the thread guide disk

from the front.

a Thread guide disk

Cut the thread with the cutter on the left side

of the machine.

a Cutter

Note

z If the thread is pulled through and cannot be

cut correctly, lower the presser foot so that

the thread is held in place before cutting the

thread. If this operation is performed, skip

step

z When using thread that quickly winds off the

spool, such as metallic thread, it may be

difficult to thread the needle if the thread is

cut.

Therefore, instead of using the thread cutter,

pull out about 80 mm (approx. 3 inches) of

thread after passing it through the thread

guide disks (marked “7”).

a 80mm or more

Lower the presser foot lever to lower the

presser foot.

a Presser foot lever

Lower the needle threader lever on the left

side of the machine until it clicks, and then

slowly return the lever to its original position.

a Needle threader lever

X The thread is passed through the eye of the

needle.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 203 204

Kommentare zu diesen Handbüchern

Keine Kommentare

Brother NV1250D Bedienungsanleitung Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nähmaschinen Brother NV1250D