Brother NX-200 Bedienungsanleitung PDF herunterladen (Seite 31)

Upper Threading 25

GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX

Pulling up the bobbin thread

When making gathers or before free-motion quilting,

first pull up the bobbin thread as described below.

Insert the bobbin into the shuttle.

• Refer to steps

through

of “Installing the

bobbin” (page 16).

Pass the bobbin thread through the slot.

Do not cut the thread with the cutter.

While lightly holding the upper thread with

your left hand, press (needle position

button) twice to raise the needle.

1 Needle position button

X The bobbin thread is looped around the

upper thread and can be pulled up.

Carefully pull the upper thread upward to pull

out the end of the bobbin thread.

Pull out about 5 cm (2 inch) of the bobbin

thread under the presser foot toward the rear

of the machine.

Reattach the bobbin cover.

Insert the tab in the lower-left corner of the

bobbin cover, and then lightly press down on

the right side.

F0_brotherE.book Page 25 Wednesday, May 21, 2003 11:38 AM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 110 111

Keine Kommentare

Brother NX-200 Bedienungsanleitung Seite 31