Brother STAR 230E Bedienerhandbuch PDF herunterladen (Seite 14)

Changing the Presser Foot

You will have to change the presser foot depending

on what you want to sew and how.

■ Snap-On Type

Raise the needle to its highest position by

turning the balance wheel toward you

(counterclockwise) and raise the presser foot

lever.

Release the foot by raising the lever at the

back of the holder.

1 Presser Foot

2 Shank

Put a different presser foot on the needle plate

so that the bar on the presser foot is in line

with the slot on the shank.

Lower the presser foot lever and fix the

presser foot onto the shank. If the presser foot

is in the correct place, the bar should snap in.

■ Presser foot installation orientation

●

Always turn off the power before you

change the presser foot. If you leave the

power on and step on the controller, the

machine will start and you may be

injured.

● Always use the correct presser foot for

the stitch pattern you have chosen. If you

use the wrong presser foot, the needle

may strike the presser foot and bend or

break, and may cause injury.

● Only use presser feet that have been

designed to be used with this machine.

Using other any presser feet may cause

an accident or injury.

CAUTION

● If the presser foot is not installed with the

correct orientation, the needle may strike

the presser foot, which may bend or

break the needle and cause injury.

CAUTION

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 62 63

Keine Kommentare

Brother STAR 230E Bedienerhandbuch Seite 14