Brother MFC4450 Bedienungsanleitung PDF herunterladen (Seite 145)

TROUBLESHOOTING PROCEDURES

14-3

MFC 4450/OP-US-5.0

Maintenance

When the temperature of the drum unit or

toner cartridge becomes too hot, the MFC will

pause its current print job and go into cooling

down mode. During the cooling down mode

you will hear the cooling fan running while the

display on the MFC shows COOLING DOWN

and PLEASE WAIT. You must wait and allow

the MFC to resume printing when it is ready.

The top cover or multipurpose sheet feeder

cover was not completely closed. Please check

each of them.

The telephone line was disconnected by the

other party during the communication. Try

calling the other party to see what happened.

Your documents were not inserted properly,

or the documents were not fed properly, or the

documents were too long.

Open the control panel and remove the

documents. (See page 13-6~8.) Then close the

control panel, press Stop and insert the

documents again, adjusting the guides on either

side of the document, and try sending the fax

again.

Original documents should be straight, non-

wrinkled, to be correctly fed. Otherwise, the

documents may occasionally jam.

Turn off the power. Then contact the Customer

Service number listed on page 14-1.

• Press the FF/Cont switch to print the data

remaining in the MFC.

• Reduce the print resolution or reduce the

complexity of your document.

The number you called does not answer or is

busy. Or, you may have reached a number that

is not connected to a fax machine. Check the

number and try again.

COOLING DOWN

PLEASE WAIT

COVER OPEN

DISCONNECTED

D

DOCUMENT JAM

MEMORY FULL

NO RESPONSE/BUSY

N

MACHINE ERROR XX

M

PRESS STOP KEY

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 168 169

Kommentare zu diesen Handbüchern

Keine Kommentare