Brother STAR 230E Bedienerhandbuch PDF herunterladen (Seite 42)

■ Securing the Stitching and Cutting the

Buttonhole

To secure the stitching, turn the material 90

degrees counterclockwise and sew Straight

Stitches to the end of the front bar tack of the

buttonhole.

Remove the material from the machine. We

recommend that you put pins across both

ends of the buttonhole as protection against

cutting the stitches.

Cut an opening in the middle of the

buttonhole with a seam ripper tool. Be careful

not to cut through any stitches.

Adjusting Buttonholes

If the stitching on the two sides of the buttonhole is

not the same, you can make the following

adjustments.

After sewing the left side of the buttonhole,

stitch the right side and observe the feeding.

1 Right row

If one side is too coarse or fine compared with

the other side, adjust the buttonhole fine

adjusting screw as shown below.

1 Buttonhole fine-adjusting screw

1 If the right side is too coarse, turn the

buttonhole fine adjusting screw with a large

screwdriver in the - direction.

2 If the right side is too fine, turn the

buttonhole fine adjusting screw with a large

screwdriver in the + direction.

• This adjustment allows both sides of the

buttonhole to be the same.

●

When using the seam ripper to open the

buttonhole, do not put your hand or

finger in the path of the ripper. The

ripper may slip and injure you.

CAUTION

1 2

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 62 63

Keine Kommentare

Brother STAR 230E Bedienerhandbuch Seite 42