51
5
5
Put the darning plate on the needle plate.
Connect the power supply plug into the wall
outlet.
6
Set the Pattern Selection Dial to Straight
Stitch (Center Needle Position).
• Before starting to sew, draw the quilting
design on the fabric.
7
Use both hands to keep the fabric firmly
stretched and move the fabric to sew over the
drawn design.
1 Quilting design (Line)
8
The length of the stitch depends on how
quickly you move the fabric and on the
machine’s sewing speed. Sew while moving
the fabric slowly.
Using the 1/4-Inch
Quilting Foot
You can use the 1/4-Inch Quilting Foot to sew fixed
seams when piecing together a quilt.
1 Seam allowance 6.5 millimetres (1/4 inch)
1
Set the Pattern Selection Dial to Straight
Stitch (Center Needle Position (2.5mm
(3/32 inch)).
2
Change the foot to the 1/4-Inch Quilting Foot.
3
Position the presser foot over the fabric and
sew, as shown in the diagram below.
■ Achieving an accurate seam allowance.
1 Beginning of stitching.
2 Align this mark up the edge of the fabric.
3 End of stitching
4 Align this mark up the edge of the fabric.
● Be careful not to touch the needle,
otherwise you may be injured.
● Use a screwdriver to tighten the presser
foot holder screw securely. If the screw is
loose, the needle may hit the presser foot
and you may be injured.
● Before you start sewing, make sure you
turn the balance wheel toward the front
of the machine to check that the needle
does not hit the presser foot.
CAUTION
1
Stitch Name Pattern
Stitch length
[mm(inch)]
Straight Stitch
(Center Needle Position)
2.5 (3/32)
1
2
1
3
4
Kommentare zu diesen Handbüchern