Brother S-7200C Bedienerhandbuch PDF herunterladen (Seite 33)

S-7200C

5. USING THE G50 OPERATION PANEL (BASIC OPERATIONS)

5-7. Using the lower thread counter

y The lower thread counter can be used to let you know approximately how much lower thread is remaining.

y The value displayed by the lower thread counter display is reduced by 1 from the initial setting value each time the sewing

machine sews 10 stitches, and a warning is given when the counter goes below“0”.



(Press for 2 seconds or more)

After about 2 seconds, the buzzer will sound and the lower thread counter display

will show the initial value which was set previously.



y When the + key is pressed, the setting increases.

y When the - key is pressed, the setting decreases.

y If you hold down the keys, the setting will change more quickly.

y If a value of “0” is set, the lower thread counter will not operate.

y The initial setting value will be accepted when sewing starts.







1. When sewing is carried out, the value shown in the lower thread counter display is reduced by 1 for every 10 stitches sewn.

(When the value goes below zero (“0”), a minus sign appears and counting continues to a maximum of “-999”.)

2. When the value goes below “0”, a warning icon (1) illuminates and an electronic buzzer sounds for 5 seconds.

3. Sewing will be possible even after the treadle is returned to the neutral position and the sewing machine stops. However,

after the treadle has been depressed backward and thread trimming has been carried out, sewing using the treadle will no

longer be possible.

4. When the RESET key (2) is pressed, the warning icon (1) will switch off and the display will return to showing the initial

values. Sewing using the treadle will then be possible.



4182M

4183M

4184M

(Initial value)

Reduces by 1

for every 10

stitches sewn

Press the RESET key (2).

(Buzzer sounds for 5 seconds)

Sewing is possible

until thread trimming

is carried out.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 79 80

Keine Kommentare

Brother S-7200C Bedienerhandbuch Seite 33