Brother S-7200C Bedienerhandbuch PDF herunterladen (Seite 57)

S-7200C

11. CLEANING

1. Turn the power switch to “OFF”.

2. Remove the screws and the set screws.

3. Apply grease to each of the holes until the grease overflows slightly.

4. Tighten the screws and the set screws in order to push the grease in.

5. Turn the machine pulley by hand to move the needle bar

up and down several times in order to disperse the

grease.

6. Use a cloth to wipe away any excess grease from around

the screws and set screws and from underneath needle

bar bush D.

7. Carry out the reset procedure given below.

After the grease has been applied, carry out the following procedure to reset the grease consumption amount.

1. While pressing the key (3) and the key (4) at the right end simultaneously, press the power ON switch.

2. “GuCt xxx” will appear in the main display (1). (“xxx” represents the amount of grease consumed. For example, “100”

means that 100% of the grease has been consumed.)

3. Press the RESET key (2) for two seconds or more.

4. The main display (1) will change to “GuCt 0”.

5. Press the ENTER key (5). The main display (1) will change to stitch number display mode and treadle operation will be

possible. (This completes the reset procedure.)

<-[]3[], []5[] specifications> <-[]5[] specifications>

4241M 4242M

Turn the

machine pulley

to lower the

needle bar until

the hole is

visible.

2138M 2139M

4243M

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 79 80

Keine Kommentare

Brother S-7200C Bedienerhandbuch Seite 57