Brother S-7200C Bedienerhandbuch PDF herunterladen (Seite 58)

S-7200C

11. CLEANING

11-3. Applying grease (-[]3[], []5[] specifications*)

[When “GrUP” appears ... When using the G10 operation panel]



If “GrUP” flashes in the display (1) and the buzzer sounds when the power ON switch is pressed, it means that it is time to

add grease. (The sewing machine will not operate at this time, even if the treadle is depressed.)

Apply grease as required, while referring to the following for details.

* If the sewing machine is of –[]0[] specifications, it is a minimum lubrication-type sewing machine, and so there is no need

to add grease.

1. Press the thread wiper key (2).

2. The display (1) will change to stitch number display mode and sewing will be possible when the treadle is depressed.

NOTE

࡮If you do not apply grease when the “GrUP” notification flashes, the notification will continue to flash each time the

power is turned on until you reset the notification by carrying out the procedure on the following page.

࡮If you continue to use the sewing machine after the “GrUP” notification appears without applying grease (or without

carrying out the reset procedure), “E100” will appear after a certain period of time and the sewing machine will be

forcibly prevented from operating for safety reasons.

If this happens, apply grease and carry out the reset procedure.

* If you continue to use the sewing machine after carrying out the reset procedure but without applying grease,

problems with the sewing machine may result.

Use Brother-specified “Grease unit (SA8837-001)”.

Using the tube

4087M

3704M

4244M

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 79 80

Keine Kommentare

Brother S-7200C Bedienerhandbuch Seite 58