Brother PJ673-K Betriebsanweisung PDF herunterladen (Seite 52)

Chapter 3

48

Defining Print Density and Other Options 3

1 Print Density

Available settings: [0]-[10]

Default setting: [6]

This parameter determines print density, which

affects the darkness of the printed document.

A lower value produces lighter print; a higher

value produces darker print.

Darker print uses more battery power, but may

be easier to read if the font or other document

content is made up of narrow lines. If battery

conservation is important, select a lower value.

NOTE

If this parameter is changed in the printer

driver’s dialog box, that setting has priority.

2 Form Feed Mode

Available settings: [No Feed], [Fixed Page],

[End of Page], [End of Page Retract]

Default setting: [Fixed Page]

This parameter determines how paper is

ejected; it determines how the printer responds

to form feed commands received from any

source.

̈ No Feed - Paper is not fed at the end of a

job. Because additional paper is not ejected

when at the end of the document, this

setting is useful when using non-perforated

roll paper.

̈ Fixed Page - Paper is fed at the end of a

job to suit the vertical length of the selected

page size (i.e., letter, legal, A4, or

user-defined size). Select this setting when

using cut sheet paper.

̈ End of Page - Paper is fed until the printer

detects that no paper remains in the input

slot, or until 14" (355.6 mm) of paper has

been fed. Select this setting when using

perforated paper.

̈ End of Page Retract - Paper is fed until the

paper sensor detects a pre-printed

end-of-page mark on the paper or the end

of the sheet. When this setting is selected,

set [Paper Type] to [Perforated Roll

Retract].

NOTE

If this parameter is changed in the printer

driver’s dialog box, that setting has priority.

3Pre-Feed

Available settings: [Disable], [Enable]

Default setting: [Disable]

If [Enable] is selected, the printer ejects a short

length of paper when the printer turns on.

When using perforated roll paper or roll paper

that is pre-printed, we recommend setting this

parameter to [Disable].

4 CR-LF Mode

Available settings: [LF=LF CR=CR],

[LF=CR+LF CR=CR+LF]

Default setting: [LF=LF CR=CR]

This parameter determines how the printer

responds when LF and CR commands

(ASCII characters 10 and 13) are received.

By default, the print head advances to the next

line for an LF (line feed) command, and the

print head returns to the left margin for a

CR (carriage return).

1

2

3

4

5

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 74 75

Kommentare zu diesen Handbüchern

Keine Kommentare