Brother PJ673-K Betriebsanweisung PDF herunterladen (Seite 8)

Chapter 1

4

Removing the Rechargeable

Ni-MH Battery

1

a Open the battery cover by pressing the

cover latch.

b Swing the cover open and remove it.

c Gently pull the battery removal ribbon

until the rechargeable Ni-MH battery

starts to tilt out of its compartment.

1 Battery removal ribbon

NOTE

If the battery removal ribbon is trapped

behind the rechargeable Ni-MH battery,

insert a thin metal object such as a

flat-blade screwdriver between the battery

and the case at the end away from the

AC/DC connector, and tilt it out of its

compartment.

d Remove the rechargeable

Ni-MH battery from the compartment.

e Gently pull the rechargeable

Ni-MH battery connector and

disconnect it from the terminal inside

the printer.

Charging the Rechargeable

Ni-MH Battery 1

Perform the following procedure to charge

the rechargeable Ni-MH battery.

NOTE

• Charge the rechargeable Ni-MH battery

immediately after purchase using the

following procedure.

• Up to 120 minutes is needed to fully

charge a rechargeable Ni-MH battery.

About 70 pages can be printed when

using a new, fully-charged rechargeable

Ni-MH battery.

a Install the rechargeable Ni-MH battery

into the printer.

b Use the AC adapter and AC power cord

to connect the printer to an AC power

socket, or use the DC cable to connect

the printer to a DC power socket.

c Make sure that the printer is turned off.

d Press and hold the (Power) button for

a few seconds until the POWER

indicator begins to blink in green.

NOTE

• Depending on the settings specified in the

PJ-673 Utility, charging of the rechargeable

Ni-MH battery may begin after the battery is

refreshed. For more information, see

Refresh Ni-MH Battery on page 46.

• While the POWER indicator is blinking in

green and orange, the power remaining

in the rechargeable battery is being

discharged and the battery is being

refreshed (see Explaining Battery Terms

on page 5).

• If there is still a considerable amount of

charge in the rechargeable Ni-MH battery,

it may not be refreshed.

• While the rechargeable Ni-MH battery

is being refreshed, press and hold the

(Power) button to stop refreshing the

battery and begin charging it.

1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 74 75

Kommentare zu diesen Handbüchern

Keine Kommentare